The EV Charging Station has three phase and single-phase capabilities. It delivers maximum 22kW AC in three phase mode or 7.3kW in single phase mode.
Wi-Fi: 802.11 b/g/n for configuration and monitoring. The internal Wi-Fi module can be configured in Access Point mode or Station mode for both the initial setup and monitoring.
It incorporates 4.3-inch LCD Touch Screen for monitoring and control.
Fully programmable RGB Light Ring around charging port, to quickly determine the device state. It can be programmed from the web interface to display different light effects based on the current state (disconnected, charging, charged etc.). The objective is to help the user see the current state from a distance.
Manual mode allows configurable output current between 6-32A. The charging power is controlled in two ways: by using the slider on the LCD touch screen or by using its web page. It allows to manually start or stop the charging process when a vehicle is connected to the charging station.
It detects when excess power is available and uses only that power to charge the vehicle.
The EV Charging Station can be configured and monitored from the GX screen devices and Remote Console.
Several options are available in the VRM Portal: real time reports, custom reports for configurable time periods, advanced functions such as remote firmware update.
Input voltage range | 170 - 265 V |
Rated charge current | 32А/phase |
Nominal power | 22 kW |
Current output range | 6 - 32 А |
Wi-fi standards | 802.11 b/g/n (2.4 Ghz only) |
Self-consumption | 15mA@230V |
Configurable Max. Current | 10 - 32 А |
Connector type | IEC 62196 Тип 2 |
Means to Disconnect | External circiut breaker (40A recommended) |
Control type | Touch screen, Web page, GX Device over Modbus TCP |
Light ring | 55 light configurable light effects available |
Protection | External RCD is required |
Storage temperature | -40°C до +80°C |
Operating temperature | -25°C до +50°C |
Humidity | 95%, non-condensing |
Data communication | Modbus TCP over Wifi |
Protection category | IP44 |
Power terminals | 6-10mm2/ AWG 10-8 |
Ventilation | not required |
Weight | 3 kg |
Dimensions (h х w х d) | 390 x 300 x 150 mm |
Safety |
IEC 61851-1, IEC 61851-22 Detection for Relay Contact welded Detection for missing protective conductor Detection for missing Ground Detection for shorted CP |