0 item(s)
Filter by

Accessories

Important items for your solar system

With the development of renewable energy sources came the need for protection and tracking devices for them. Their common name is accessories. They must meet the specific needs of the installation and in most cases cannot be replaced by general purpose ones.

Characteristic requirements that must be observed:

  • To be designed for direct current operation;
  • Nominal and maximum operating current;
  • Nominal and maximum operating voltage;
  • Specific requirements, according to the application.

Conclusion

Accessories for photovoltaic systems and inverters are an important and indispensable part of the solar installation. They must operate on direct current and be suitable for the current and voltage of the system.

Please take a look at our offers presented below and make your choice now.

  1. This cable is intended for on/off control of BlueSolar or Smart Solar MPPT solar chargers with a VE.Direct interface.
  2. Blade for 300W-500W wind turbine. Length = 1100mm
  3. Carry Case for Blue Smart IP65 Chargers and accessories
  4. VE.Direct to BMV60xS cable 3m . To be used for Battery monitor 600 by Victron Energy
  5. The VE.Direct to USB interface connects products with a VE.Direct connection to devices with a USB port, for example a computer. With this cable it is also possible to connect more than two VE.Direct products to a single CCGX.

  6. RS485 to USB Interface 1,8m Victron Energy Adapter cable for connecting ET112 or ET340 energy meter to the Color Control GX system control monitor or the Venus GX system monitoring.
  7. Blade for 300W-500W wind turbine. Length = 1240mm +/- 10mm
  8. Mega Fuse 200A; maximum voltage: 58V
  9. Mega Fuse 250A; maximum voltage: 58V
  10. VE.Bus to BMS 12-200 alternator control cable. Victron Energy
  11. RS485 to USB Interface 5m Victron Energy Adapter cable for connecting ET112 or ET340 energy meter to the Color Control GX system control monitor or the Venus GX system monitoring.
  12. Battery Switch ON/OFF 275A

    Voltage rating 48V

  13. A single blade for 500W wind turbine without flange. Length: 1200mm
  14. Second hand product! Blade for 1000W wind turbine without flange
  15. Wall mounted enclosure for Color Control GX and BMV or MPPT
  16. We are official Victron Energy importer and service center for Bulgaria

  17. The argo diode battery combiner is used to guarantee continuous DC power to mission critical equipment.

    With the diode battery combiner two DC power sources can be used in parallel to supply the mission critical load. Failure of one source will not interrupt power to the critical load.

  18. The BatteryProtect disconnects the battery from non essential loads before it is completely discharged (which would damage the battery) or before it has insufficient power left to crank the engine.

    Maximum continuous load current 65A

    Peak current (during 30 seconds) 300A

    Operating voltage range 6-35V

  19. DC SWITCH DISCONNECTOR 50A 1000Vdc

    Certified according to the European standard IEC EN 60947 (TÜV)

    Mounting on DIN rail

  20. Second hand Blade for 2500W wind turbine without flange
  21. Using the VE.Direct to Bluetooth Smart dongle you can display your BMV or MPPT information on iOS and Android devices, using the VictronConnect app. View information wirelessly such as battery status and solar panel power, plus other useful data..
  22. Ние сме официален вносител и сервиз на Victron Energy

    Измерва зарядния ток и пресмята енергията от мрежови инвертор , който е включен към АС входа или изхода на MultiPlus или Quattro инвертори.

  23. Battery combiner used in campers, yachts, caravans, etc.
    • Diode battery isolator allow simultaneous charging of two or more batteries from one alternatoр
    • Maximum charge current 80(A)
  24. The BatteryProtect disconnects the battery from non essential loads before it is completely discharged (which would damage the battery) or before it has insufficient power left to crank the engine.

    Maximum continuous load current 100A

    Peak current 600A

    Operating voltage range 6-35V

  25. The Smart BatteryProtect disconnects the battery from non essential loads before it is completely discharged (which would damage the battery) or before it has insufficient power left to crank the engine.

    Maximum continuous load current 65A.

    Peak current (during 30 seconds) 250A.

    Operating voltage range 6-35V

  26. The MK3 - USB interface is used to connect a VE.bus product to a computer via USB port.
  27. The Smart BatteryProtect disconnects the battery from non essential loads before it is completely discharged (which would damage the battery) or before it has insufficient power left to crank the engine.

    Maximum continuous load current 100A.

    Peak current (during 30 seconds) 600A.

    Operating voltage range 6-35V

  28. The BatteryProtect disconnects the battery from non essential loads before it is completely discharged (which would damage the battery) or before it has insufficient power left to crank the engine.

    Maximum continuous load current 220A

    Peak current (during 30 seconds) 600A

    Operating voltage range 6-35V

  29. The BMS will: 1.Disconnect or shut down the load whenever the voltage of a battery cell falls to less than 2,5V. 2.Stop the charging process whenever the voltage of a battery cell increases to more than 4,2V. 3.Shut down the system whenever the temperature of a cell exceeds 50°C.
  30. The Smart BatteryProtect disconnects the battery from non essential loads before it is completely discharged (which would damage the battery) or before it has insufficient power left to crank the engine.

    Maximum continuous load current 220A.

    Peak current (during 30 seconds) 600A.

    Operating voltage range 6-35V

  31. Prevent any electrolytic current

    Maximum AC current 16A

    Peak current (20 ms) 1600A

  32. Battery combiner used in campers, yachts , caravans, etc. Can be used in 12V and 24Vdc systems
  33. Protect solar panels from damage and eliminate any safety hazards.
  34. Ние сме официален вносител и сервиз на Victron Energy
    Неръждаем контакт с капак за брегово захранване на яхти кемпери и др. 32A/250Vac (2p/3w)

  35. Rotating body for 500W wind turbine with bearings
  36. 3pcs blades and 1 flange with radius 1020mm Can be used as spare parts in our 300W wind turbines
  37. The BatteryProtect disconnects the battery from non essential loads before it is completely discharged (which would damage the battery) or before it has insufficient power left to crank the engine.

    Maximum continuous load current 100A

    Peak current 250A

    Operating voltage range 24-64V

  38. Protect conductors and solar panels from damage and eliminate any safety hazards
  39. Protective equipment (surge arrester and PV switch) for your inverter and / or solar charge controller

  40. The Smart BatteryProtect disconnects the battery from non essential loads before it is completely discharged (which would damage the battery) or before it has insufficient power left to crank the engine.

    Maximum continuous load current 100A.

    Peak current (during 30 seconds) 250A.

    Operating voltage range 24 - 70V.

  41. Protective equipment (surge arrester and PV switch) for your inverter and / or solar charge controller

  42. The surge protection device type 1+2 for direct and indirect lightning strikes.

    We are the official representative and service of Fronius for Bulgaria.

  43. Features

    • Bluetooth Smart enabled;
    • Fully programmable;
    • Adaptive 3-stage chargealgorithm: bulk absorption float;
    • Remote on-off;
    • Short circuit proof and can be paralleled to increase output current;
    • High temperature protected;
    • IP43 protection;
    • Screw terminals;
    • Input fuse (not replaceable).

     

  44. Features

    • Bluetooth Smart enabled;
    • Fully programmable;
    • Adaptive 3-stage chargealgorithm: bulk absorption float;
    • Remote on-off;
    • Short circuit proof and can be paralleled to increase output current;
    • High temperature protected;
    • IP43 protection;
    • Screw terminals;
    • Input fuse (not replaceable).

     

  45. Features

    • Bluetooth Smart enabled;
    • Fully programmable;
    • Adaptive 3-stage chargealgorithm: bulk absorption float;
    • Remote on-off;
    • Short circuit proof and can be paralleled to increase output current;
    • High temperature protected;
    • IP43 protection;
    • Screw terminals;
    • Input fuse (not replaceable).